Glock +2 Magazine baseplate

Shipping Notice: Due to certain state restrictions, we cannot ship this product to the following states: California, Connecticut, Delaware, Hawaii, Illinois, Maryland, Massachusetts, New Jersey, New York, Oregon, Rhode Island, Vermont, Washington, and the District of Columbia. 

If an order is placed from one of these states, it will be canceled and refunded minus Stripe payment processing fees. (typically 2.9% + $0.30). Check your shipping state before purchasing.

3D-printed in tough PETG plastic, this plus-two magazine extension gives you two extra rounds while upgrading your grip with a sleek, extended look. Same durable material and rock-solid design as my cosmetic bases, now with real capacity.

Compatible with most double-stack 9mm magazines including Glock factory, KCI, Magpul, and Second Amendment brands. Does not fit ETS or single-stack mags.

It features a heat-set threaded M3 insert with a low-profile dome-head screw for a secure, rattle-free fit. Sharp tactical lines and extra grip area help with faster reloads.

Install: You'll need a slim punch or Glock Armorer’s tool to remove the factory base plate. The factory spring stays in place. Slide on the new extension and secure it with the included M3 screw using an M3 hex key (not included).

Care & Longevity: Store in a cool, dry place. Avoid temps over 140°F. Clean with a damp cloth and mild soap. Avoid hard drops.

Tested on Gen 3 and Gen 5 Glock mags with no issues over time. For best performance I recommend pairing it with an extra-power spring, though many factory springs handle the extra two rounds fine. Always test your setup before relying on it.

Happy to answer questions. Stay safe out there!